Product features:
Frame welding firm small combination machine, digital temperature and time control, automatic alarm, temperature and time automatic circulation, this small combination of the combination of its functions, simple operation, small and practical and much favored by customers.
Technical parameters:
Power: 550W
Voltage: 220/110 V
Temperature range: 0-399 degrees centigrade
Time range: 0--999Sec
Fever size: 8*14cm
Operation steps
Step 1: insert the power cord
Step two: open the power switch.
Step three: adjust the time and temperature required.
Step four: after adjusting the thermometer and schedule, wait for the machine to heat up.
Step five: after the temperature is up, the thermometer will turn on the green light.
Step six: put the printed articles on the silicone pad.
Step seven: after the item is steady, press the handle. The hot press begins. The countdown time.
Step eight: hot stamping, the buzzer ringing.
Step nine: take out the ironed items. If the hot tear paper is cold, please wait 5-10 seconds to tear up the hot paper. If it is the hot tear hot paper, if the hot stamping is finished, please tear the ironing paper immediately.
The whole machine must have a suitable ground to protect the ground
The successful hot stamping needs the correct time, temperature and pressure, the thickness of the clothes and the material and the various kinds of drawing paper affect the effect of stamping. All kinds of scald paper should be tried to burn the sample, so it can be produced in mass.
Six. Maintenance items:
Pressure: if the pressure is not enough or too big, the five angle heart control knob after adjusting the machine can increase the pressure to clockwise direction, and vice versa, reduce the pressure; do not exceed 30 kilograms force, otherwise it may cause the handle deformation.
Time: when the buzzer does not sound or ring, the contact point of the micro switch in the tail box should be checked if the distance is moderate. If it is not moderate, it must be adjusted to the appropriate position.
Temperature: when the temperature is reached, the pointer of the thermostat is in the "0" position (about 15 minutes to 180 degrees). If the heating board is not heated for several minutes, check the circuit.
Be careful:
The whole machine must have a suitable ground to protect the ground
The successful hot stamping needs the correct time, temperature and pressure, the thickness of the clothes and the material and the various kinds of drawing paper affect the effect of stamping. All kinds of scald paper should be tried to burn the sample, so it can be produced in mass.
